Witter DT93C Instructions

MATERIALS
A 1 Tubular Mainframe with European Facing to 94/20/EC A50-1
B 1 Coupling Packer
D 4 M12 x 35mm Bolts and Nyloc Nuts
D1 2 Side Mounting Cleats
E 6 M12 x 35mm Bolts, Nyloc Nuts and Flat Washers (25mm O.D.)
CB 2 M16 x 65mm Coupling Bolts, Nuts and Lock Washers
Z 1 ZEP35 Electrical plate (not shown)
FITTING
1. Loosely attach Side Mountings (D1) to the holes provided on the vehicle with Bolts (E).
2. Attach Mainframe (A) to the side mounts with Bolts (D) and finally tighten all bolts. Use Packer (B) when lower
coupling holes are used.
Note: This towbar must be used with either a Witter Towball (part number Z1X) or Class A50-1 or A50-X towball dimensionally
Conforming to A50-1 with a 'D' and 'S' value greater than or equal to that of the towbar.
Please refer to the vehicle specification for the trailer weight and nose limits, which must be observed.
Recommended torque settings: M8 - 27Nm, M10 - 53 Nm, M12 - 95 Nm, M14 - 150 Nm, M16 - 214 Nm
WITTER TOWBARS
Deeside Ind. Park, Deeside, CH5 2NY
Fitting
Instructions
µW0001DT93B-FIT$011103150000QÄ
W0001DT93B-FIT$011103150000
For NISSAN TERRANO II 1993-
and FORD MAVERICK 1993-
witter-towbars.co.uk
DT93C
TOWBAR
Issue 1