Secure The Solar Panel To The Rv Roof; Electrical Connection - Furrion FSFP16MW2-BL Manuel D'utilisation

regulations. A minimum distance of 13/16" (20mm) between the roof plane and the
frame of the module is generally recommended.
–
Always observe the instructions and safety precautions included with the module
support frames.
–
Before installing modules on a roof, ensure that the roof construction is suitable.
In addition, any roof penetration required to mount the module must be properly
sealed to prevent leaks.
–
Observe the linear thermal expansion of the module frames [the recommended
minimum distance between two modules is 7/16" (10mm)].
–
Always keep the back-sheet of the panel free from foreign objects or structural
elements, which could come into contact with the panel, especially when the
panel is under mechanical load.
–
Ensure panels are not subjected to wind or snow loads exceeding the maximum
permissible loads (290lbs/130kg), and are not subject to excessive forces due to
the thermal expansion of the support structures.

Secure the Solar Panel to the RV Roof

Mount the solar panel through the such that at least 4 of the mounting feet have
screws penetrating the metal or wooden framing trusses. For fixed mounting, the
points should be installed in the frame on the long side of the panel, as shown below:

ELECTRICAL CONNECTION

To power the Solar Photovoltaic System properly, the following Furrion components
are also required except the solar panel. Please contact Furrion authorized dealer to
purchase the product(s) as required and refer to the individual instruction manual that
comes with the product to set up the system.
Furrion Model#
C-FSFP37MW-A02/C-FSFP16MW-A02
FSCC30PW-BL/FSCC60PW-BL
C-FSCC60PW-A01/C-FSCC60PW-A02
CCD-0005510 Rev: 04-15-22
Description
L-Bracket/Z-Bracket
MPPT Solar Charge Controller
Temperature Sensor
- 7 -