Before You Start - D-Link AC1200 Guide D'installation Rapide

Before you Start

• Users with DSL providers - If you are using a PPPoE connection, you will need
your PPPoE user name and password. If you do not have this information, contact
your Internet provider. Do not proceed until you have this information.
• Users with Cable providers - Make sure you unplug the power to your modem.
In some cases, you may need to turn it off for up to 5 minutes.
• Advanced Users - If your Internet Service Provider (ISP) provided you with a
modem/router combo, you will need to set it to "bridge" mode so the DIR-822
router can work properly. Please contact your ISP or refer to the user manual for
your modem/router device.
Connect your Router
1
Unplug the power to your DSL or Cable modem.
2 Connect an Ethernet cable from the Internet port of the router to the
Ethernet port on your DSL or Cable modem.
Ethernet Port
4
4 3 2 1
Modem
Ethernet Cable
Modem
DIR-822
INTERNET
POWER PORT POWER WPS
Internet Port (yellow)