Charging; Operating Instructions; Maintenance Instructions - Schumacher Electric SL360R Guide D'utilisation

5.

CHARGING

IMPORTANT! CHARGE THE WORK LIGHT IMMEDIATELY AFTER PURCHASE,
AFTER EACH USE, AND AT LEAST EVERY 6 MONTHS. Failure to do this will
reduce the battery's capacity and may void the warranty.
5.1 Using the 120V AC charger: Plug the charger's small connector into the back of
the work light, and then plug the AC adaptor into a 120V AC outlet.
5.2 Using the 12V DC accessory plug: Plug the small connector of the accessory
plug into the back of the work light, and then plug the other end into the 12V DC
power outlet.
5.3 Plug into your power supply. The charging LED will light RED, to indicate
charging has begun.
5.4 When the battery is fully charged, the charging LED will change to GREEN.
5.5 Recharge the work light after use, and at least every 6 months.
6.

OPERATING INSTRUCTIONS

6.1 Hang the work light, using the hooks on the back. When hung from a single hook,
the work light can be rotated 360° for more precise positioning.
6.2 The magnets may be used instead. Attach to any ferrous metal surface.
6.3 Direct the lens away from your eyes before turning on the work light.
6.4 Press once to turn on the 3W end LED.
Press a second time to turn on the high-power SMD LEDs.
Press a third time to turn on the low-power SMD LEDs.
Press to turn off.
6.5 Recharge the work light after use, and at least every 6 months.
7.

MAINTENANCE INSTRUCTIONS

7.1 After use and before performing maintenance, unplug and disconnect the work light.
7.2 Use a dry cloth to wipe any dirt or oil from the chargers, cords and case.
7.3 Ensure that all of the work light's components are in place and in good working
condition.
7.4 Servicing does not require opening the unit, as there are no user-serviceable parts.
7.5 Any servicing should be performed by qualified service personnel.
• 8 •
VOTING