Publicité
Les langues disponibles
Les langues disponibles
50022893-001 COVER PLATE ASSEMBLY
INSTALLATION
When Installing this Product...
1. Read these instructions carefully. Failure to follow them could damage the product or cause a hazardous
condition.
2. Check ratings given in the instructions and on the product to make sure the product is suitable for your
application.
3. Installer must be a trained, experienced service technician.
4. After installation is complete, check out product operation as provided in these instructions.
CAUTION
Electrical Hazard.
Can cause electrical shock or equipment damage.
Disconnect power before beginning installation.
Mount Cover Plate
Mount Cover Plate Directly to Wall (See Fig. 2)
1. Pull the wires through the wire hole on the cover plate and wall plate.
2. Position the cover plate and wall plate on the wall with the arrows pointing up. Level the wall plate for
appearance only.
3. Use a pencil to mark the mounting holes for your thermostat.
4. Remove the cover plate and wall plate from the wall and drill two 3/16-in. holes in the wall (if drywall) as
marked. For firmer material such as plaster, drill two 7/32-in. holes. Tap the wall anchors (provided with
the thermostat) into the drilled holes until flush with the wall.
5. Pull the wires through the wire hole on the cover plate and wall plate. Position the cover plate and wall
plate on the wall anchors.
6. Insert the mounting screws (provided with the thermostat) into the wall anchors. Check leveling, if desired,
and tighten the mounting screws.
WALL OPENING
WALL ANCHORS (2)
(PROVIDED WITH
THERMOSTAT)
Fig. 2. Mount cover plate, wall plate and thermostat directly to wall.
69-2064EFS—03
COVER PLATE
WIRE
MOUNTING HOLES (2)
WIRE HOLE
2
WALL PLATE
MOUNTING SCREWS
(PROVIDED WITH THERMOSTAT)
THERMOSTAT
M27009A
Publicité
