Horizon Global 75270 Instructions D'installation

Frame rail
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 75270F
Wrenches: 19mm
Drill Bits: None
Frame rail
Note: Fasteners typical both sides
1 1 1 1
Qty. (6) Bolt M12 X 1.25 X 35mm CL8.8
2 2 2 2
Qty. (6) 1/4" X 1-1/2" X 3" Blocks
Note: If present, remove plastic appearance panel which covers driver's side frame rail. Return appearance panel and fasteners
to vehicle owner.
1. Lower vehicle exhaust and raise hitch into position.
2. Install the six (6) M12 fasteners and blocks as shown above.
Note: 1999-2004 models use the most forward slots in the hitch side brackets.
3. Re-install vehicle exhaust.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
©
2004, 2006, 2008, 2009, 2010, 2011, 2015, 2018 Horizon Global™ Corp - Printed in Mexico
Installation Instructions
Honda Odyssey
Fascia
1999-2004 Models
Use forward slot
2005 & Later Models
Installation shown
Existing weld nuts
Tighten all M12 Cl8.8 fasteners with torque wrench to 68 Lb.-Ft. (92 N*M)
Do Not Exceed Lower of Towing Vehicle
Manufacturer's Rating or
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Wiring Access Location: SUV3
3 3 3 3
Qty. (6) Conical Washer 1/2"
Sheet 1 of 3
Part Numbers:
75270
44174
87479
78234
U-HAUL
Max Gross Max Tongue
Trailer WT (LB) WT (LB)
5000 (2270 Kg) 675 (306 Kg)
4500 (2043 Kg) 675 (306 Kg)
2
1
3 3 3 3
Conical Washer
Teeth side
Against hitch
75270N 10-30-18
Form: F205 Rev A 5-6-05
Rev. M