Epson VS210 Guide Rapide

VS210/VS310/VS315W
Quick Setup
Before using the projector, make sure you read the safety instructions in the
online User's Guide.
Note: These illustrations show the VS310/VS315W, but the instructions are the
same for the VS210 unless otherwise noted.
Connect the projector
Choose from the following connections. See the sections below or the online
User's Guide for details.
Computer
USB Port
Connect the square end of a USB cable to the projector's
(square) port. Connect the flat end of the cable to any USB port on your
computer.
Windows 2000 SP4 or later: After turning on the projector, follow
®
the on-screen instructions to install the Epson USB Display software
(EMP_UDSE.EXE; only on first connection). If the software screen does not
display automatically, open My Computer or Computer, then double-click
EPSON_PJ_UD.
Mac OS X 10.5.1 or higher: After turning on the projector, the setup folder
®
for USB Display appears in the Finder. Double-click USB Display Installer and
follow the on-screen instructions to install the Epson USB Display software
(only on first connection).
Note: If you have problems installing the USB Display software, make sure the
USB Type B setting in the projector's Extended menu is set to USB Display.
See the online User's Guide for instructions.
Monitor Port
Connect one end of a VGA cable to the projector's Computer port, and the
other end to your computer's
switch it to external display (see "Troubleshooting"). You can also connect an
audio cable.
Video Device
Connect up to 3 video devices and use the remote control to switch
between them.
USB cable
VGA cable
USB TypeB
monitor port. If you are using a laptop,
Audio cable
S-Video cable
Component video to VGA cable
RCA video cable (composite video)
Turn on your equipment
1
Turn on your computer or video source.
2
Plug in the projector. The power light on the projector turns orange.
3
Open the A/V Mute slide all the way.
4
Press the power button on the projector or remote control. The
projector beeps, the power light flashes green, and then stays on.
Note: To shut down the projector, press the
unplug it. You don't have to wait for the projector to cool down.
5
The default language of the menu system is English. To select another
language, press the Menu button on the remote control. Select
Extended and press Enter. Select Language and press Enter. Select
your language and press Enter. Press the Menu button to exit the menu
system.
Adjust the image
1
If you don't see an image, press the Source Search button on the
projector or remote control to select the image source.
Note: If you still see a blank screen or have other display problems, see the
troubleshooting tips on the right.
2
To raise the image, press the foot release button and lift the front of the
projector. Release the button to lock the foot in position.
power button twice, then