Graco Connext Manuel Du Propriétaire page 14

Attaching the Booster to the
Vehicle Seat
Lift release lever on side of booster and pull
14
strap to loosen.
Remove connector from bar on back of
15
booster.
Repeat on other side of booster.
Attach connectors to vehicle lower anchors.
16
NEVER put two connectors on one vehicle
17
anchor.
Pull firmly on connectors to be sure they are
18
attached.
These connectors should always be attached,
however their function is to retain the restraint
during an impact, when it is not being used.
To remove booster, lift release levers on sides
19
of booster and pull slightly away from seat.
Push connector in,
20
lift connector up and pull out (away from
21
anchor point). Repeat on other connector.
14