Attwood Turbo 3000 Instructions D'installation

3
®
Turbo In-Line Bilge Blowers
Installation Instructions
SAVE THESE INSTRUCTIONS
Form Number 69255 Rev. G
Specification
Model No. Voltage
Turbo 3000 13.6
Turbo 4000 13.6
Turbo 4000 (24V) 24
*In system = 3 ft. of duct with one 90° bend, a collector box and louvered vent on discharge
side of blower.
Blower models 1733, 1734, 1743, 1744 and 1745 (24V, 4") are water resistant. Models
1731, 1732, 1741 and 1742 are not water-resistant. All Turbo blowers are ignition protected.
Connect to 12-volt D.C. systems only (24 volt for Model 1745).
WARNING:
To prevent personal injury, always disconnect electrical connection when installing
or servicing this product.
Always use a fuse with amperage rating specified for the blower model.
Before starting engines, operate blower a minimum of four minutes, then check
engine compartment for fume odor. Operate blowers when motoring below 5 miles
per hour.
Do not operate in area of high heat over 160° F (71°C).
Do not operate while refueling.
MOUNTING INSTRUCTIONS
1. Select a flat mounting surface high above the bilge, clear of moisture from spray or
deck wash.
2. Position blower with the flow arrow pointing toward exhaust vent. Also, mount blower
at an angle to prevent moisture build-up. See Figure 1.
3. Mark mounting holes. Drill holes for #10 screws and secure unit in place using stainless
steel screws. Do not over tighten screws.
4. Twist duct hose over exhaust and intake openings on blower. Ensure the retainer tabs
engage corrugated rings of hose.
5. Install tie strap or hose clamp on the hose. Position the strap or clamp around blower
housing, beyond the tabs. Tighten the strap. Do not overtighten straps or clamps.
6. Route intake end of hose directly to the lowest point in the bilge, with as few bends as
possible. The hose pick-up must not be low enough to become submerged in bilge
water. See Figure 1.
7. Route exhaust end of hose directly to vent or vent collector box, with as few bends as
possible. Connect hose securely to vent. See Figure 1.
Figure 1 Vertical
Transom Mount
ATTWOOD BILGE BLOWERS LIMITED WARRANTY:
ATTWOOD CORPORATION, 1016 North Monroe, Lowell, Michigan 49331, ('Attwood')
warrants to the original consumer purchaser that this Attwood Bilge Blowers, numbers 1731,
1732, 1741, 1742 will be free from defects in materials and workmanship under normal use
and service for a period of one (1) year. These models are not intended for use in applications
which allow direct contact with water or other liquids. Evidence of such product damage voids
this warranty. Attwood also warrants the Attwood Bilge Blowers, numbers 1733, 1734, 1743,
1744, will be free from defects in materials and workmanship under normal use and service
for a period of three (3) years from the date of original consumer purchase. This warranty
does not extend to any batteries or fuses used with the blower. This limited warranty is not
applicable if the bilge blower has been damaged by accident, improper installation,
unreasonable use, lack of proper maintenance, unauthorized repairs or modifications, or
other causes not arising out of defects in materials or workmanship. Attwood's obligations
under this warranty are limited to repair of the product at Attwood's plant or replacement of
the product at Attwood's option and at Attwood's expense. Any expenses involved in the
removal, reinstallation, or transportation of the product are not covered by this warranty. The
product must be returned to Attwood's plant at the address indicated above postage prepaid,
with proof of original purchase including date. If Attwood is unable to replace the bilge blower
CFM CFM Amp
Open Flow In System* Draw
145 100 3.1
230 125 4.4
230 125 2.5
Horizontal Deck
Transom Mount Mount
WIRING INSTRUCTIONS
1. Fuse holder must be installed within 72" (183cm) of the battery (+) terminal. See table
for proper fuse size.
Connect ON/OFF switch into the circuit and mount it in the dash control panel.
2. If your boat is not equipped with a blower "WARNING" label like the one shown below,
please contact our customer service department for a free label — Part No. 9158WR.
Figure 2
03-10
Fuse
Size
FLOW
4-amp
ARROW
•
8-amp
4-amp
ABYC H2/IS0 9097 MARINE BLOWER PERFORMANCE SPECIFICATIONS
3" Blowers
1731, 1732, 1733, and 1734
Performance at 12 VDC
1.5
1.0
0.5
0 50
AIR FLOW (CFM)
4" Blowers
1741, 1742, and 1744
Performance at 12 VDC
2.5
2.0
1.5
1.0
0.5
0 50 100
AIR FLOW (CFM)
and repair is not commercially practicable or cannot be timely made, or if the original consumer
purchaser is willing to accept a refund in lieu of repair or replacement, Attwood may refund
the purchase price, less an amount for depreciation. The acceptance by Attwood of any
product returned or any refund provided by Attwood shall not be deemed an admission that
the product is defective or in violation of any warranty.
THIS WARRANTY IS ATTWOOD'S ONLY EXPRESS WARRANTY OF THIS PRODUCT.
NO IMPLIED WARRANTY SHALL EXTEND BEYOND THREE (3) YEARS FROM THE DATE
OF ORIGINAL CONSUMER PURCHASE. ATTWOOD SHALL NOT BE LIABLE FOR ANY
DAMAGES FOR LOSS OF USE OF THIS PRODUCT, NOR FOR ANY OTHER INCIDENTAL
OR CONSEQUENTIAL DAMAGES, COSTS OR EXPENSES.
Some states do not allow limitations on how long an implied warranty lasts or the exclusion
or limitation of incidental or consequential damages, so the above limitations and exclusions
may not apply to you. This warranty gives you specific legal rights and you may have other
rights which may vary from state to state.
© 2003 Attwood Corporation
1016 N. Monroe Street, Lowell, MI 49331-0260 www.attwoodmarine.com
YELLOW
1731, 1732, 1733, and 1734
Performance at 13.6 VDC
1.5
3.5 - 10,500
1.0
3.0 - 9,500
0.5
2.5 - 8,500
0
100 150
1741, 1742, and 1744
Performance at 13.6 VDC
2.5
2.0
6.0 - 9,500
1.5
5.0 - 9,000
1.0
4.0 - 8,500
0.5
3.0 - 8,000
0 50
150 200 250
WARNING
GASOLINE VAPORS CAN EXPLODE
BEFORE STARTING ENGINE:
OPERATE BLOWER FOR 4 MINUTES
CHECK ENGINE COMP'T FOR GAS OR VAPORS
RUN BLOWER WHEN BELOW CRUISING SPEED
72" (183cm)
MAX.
BATTERY
3" Blowers
3.5 - 10,500
3.0 - 9,500
2.5 - 8,500
50 100 150
AIR FLOW (CFM)
4" Blowers
6.0 - 9,500
5.0 - 9,000
4.0 - 8,500
3.0 - 8,000
250
100 150 200
AIR FLOW (CFM)