Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
DESCRIPTION
-
Mono power stage 1,250 W maximum, 1,000 W RMS with low impedance loudspeaker output 4 Ω and
100 and 70 V lines. Specially suitable for PA and audio system applications.
-
Two protection circuits: for temperature and short circuit in the output, activated when an anomaly is
detected in the operation, cutting off audio output to avoid damage.
CONTROLS AND FUNCTIONS
FRONT PANE
1.- SIGNAL: output signal LED indicator.
2.- CLIP: signal peak LED indicator. They light up when an input signal is detected with a level that is too
high or when there is an excessive output level that could cause damage.
3.- PROT: protection LED indicator. It lights up when the protection is activated in the amplifier because of
temperature or short circuit. With protection enabled, the audio output of that channel is cut off. In this
case, switch off the power stage, correct the causes of the fault and let the device set itself for a few
minutes before switching it on again.
4.- POWER: power stage LED power on indicator.
5.- Power stage on/off switch.
REAR PANEL
1.- BREAKER: 10 A resettable fuse. When the power amplifier is overloaded or there is a surge, the fuse
will cut out to avoid damage. It is reset by pressing it.
2.- Power supply voltage selector.
3.- OUTPUTS: loudspeaker output terminals. To connect the loudspeakers in low impedance 4 Ω or in
high impedance lines of 100 or 70 V. Connect the loudspeaker line between the COM terminal and the
required impedance or line. Only use one loudspeaker output.
4.- GND LIFT: this selector is normally in the GND position (left). If the installation has ground noises, place
the selector in the LIFT position (right) to disconnect the ground and the device's ground.
5.- LINK: aux line signal level output, 2 x unbalanced RCA connectors, euroblock, XLR and unbalanced
6.3 mm jack. Use only one output connector. Allows connection to another power stage in cascade.
POWER
PROT
CLIP
SIGNAL
1 2 3 4
1
POWER
PROT
BREAKER
CLIP
10
A
SIGNAL
M
P
230 V
115 V
1 2 3 4
~ 230/115 V AC, 50/60 Hz. 1,400 W
1
2
8
9
BREAKER
10
A
M
P
230 V
115 V
~ 230/115 V AC, 50/60 Hz. 1,400 W
8
9
POWER
5
2
3
ON
OFF
COM
4
70 V
100 V
FS-11000E
1,250 W MAX., 1,000 W RMS
POWER
OUTPUTS
5
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: SHOCK HAZARD - DO NOT OPEN
RISK OF FIRE-REPLACE FUSE AS MARKED
3
COM
4
70 V
100 V
FS-11000E
1,250 W MAX., 1,000 W RMS
OUTPUTS
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: SHOCK HAZARD - DO NOT OPEN
RISK OF FIRE-REPLACE FUSE AS MARKED
- 2 -
ON
OFF
4
5
6
GND LIFT
INPUT GAIN
L
L
MIN
- +
G
G
R
R
UNBAL
UNBAL
BALANCED
BALANCED
LINK
4
5
6
7
GND LIFT
INPUT GAIN
L
L
MIN
- +
G
G
R
R
UNBAL
UNBAL
BALANCED
BALANCED
LINK
INPUT
7
MAX
- +
INPUT
MAX
- +
Publicité
Table des Matières
