Considerations For Installation; Installation - vds LINEAR 11 Manuel Technique

CONSIDERATIONS FOR INSTALLATION

The installation and testing operations must be performed solely by qualified personnel in
·
order to guarantee the proper and safe operation of the automatic gate.
The company declines any responsibility for damage caused by incorrect installations due
·
to incompetence and/or negligence.
· Before assembling the automatism, check that the gate is in perfect working order, hangs
well on its hinges and is suitably lubricated. It must also comply with the safety standards
in force in the country of installation..
1 - Before fastening the brackets provided, establish the coordinates using the data given in
Table 1, bearing in mind that they are valid if the operator is at maximum extension minus one
centimetre of the available stroke (CD) when the gate is closed to obtain maximum working
efficiency.
2- Data B in the table, with reference to the single values A, are to be considered as values
(recommended).
3- To anchor the piston, use the fastening brackets provided.
COORDINATES AND TABLE
1. Establish coordinates A + B that are
to be used.
2. Note: The stroke used (CU) of the
operator must never be equal or
greater than the available stroke (CD)
3. The sum of coordinates A + B,
establishes the stroke used CU .
TABLE 1
Opening angle
90° Available stroke = 400mm
90° Available stroke = 500mm
Note1: A+B = CU (Stroke used)

INSTALLATION

A
160
175
190
200
250
CD = (Available stroke) = 400/500 mm
B Cu
160 320
175 350
190 380
200 400
250 500