Télécharger Imprimer la page

Publicité

Liens rapides

TM
Hardware Kit &
Lower Mounting Bracket (X2)
FOR USE WITH VEHICLES EQUIPPED WITH TWO ROOF TOP CROSS BARS
Kayak Carriers
Installation & Loading Instructions - Please Read Before Beginning
1A
Veuillez lire les instructions avant d'entreprendre l'installation et le chargement
IMPORTANT WARNING: All vehicular transports are potentially hazardous. Any person(s) using EcoRack products are personally responsible
for following the given directions for use and/or installation and accepts full responsibility for any and all damages or injury of any kind including
1
death, which may result from their use and/or installation.
It is critical that all EcoRack racks and accessories be properly and securely attached to your vehicle. Improper attachment could result in a serious
accident, and could cause serious bodily injury or death to you or to others. You are responsible for securing the racks and accessories to your car,
checking the attachment's prior to use, and periodically inspecting the products for adjustment, wear, and damage.
You must read and understand all of the instructions and cautions supplied with your EcoRack products(s) prior to installation or use. If you do not
understand all of the instructions and cautions, or, if you have no mechanical experience and are not thoroughly familiar with the installation
procedures, you should have the product installed by a professional installer.
MISE EN GARDE IMPORTANTE: Tout transport d'un chargement sur le toit d'un véhicule est potentiellement dangereux. Une personne qui
utilise les produits EcoRack doit suivre sans faute les instructions d'installation et d'utilisation fournies et assume l'entière responsabilité pour
tout dommage ou toute blessure, y compris un décès, pouvant résulter d'une telle installation ou utilisation.
Il est essentiel de fixer correctement et solidement les supports et les accessoires à votre véhicule. Une mauvaise installation ou attache pourrait
provoquer un accident, entraîner des blessures corporelles graves à vous et aux autres et même causer la mort. Vous avez la responsabilité de
fixer solidement les supports et les accessoires à votre véhicule, de vérifier l'installation avant l'utilisation et d'inspecter périodiquement le produit
pour déceler tout signe d'usure ou de dommage ou tout problème d'ajustement.
Vous devez lire et comprendre les instructions et les mises en garde fournies avec les produits EcoRack avant l'installation et l'utilisation. Si vous
. Insert Mounting Bolt through one hole of a Jawz adapter.
ne comprenez pas les instructions et les mises en garde ou si vous ne possédez pas d'expérience en mécanique et ne connaissez pas à fond les
Insert washer and loosely apply a T-knob. See image 2.
procédures à suivre d'installation, vous devriez faire monter et poser le produit par un installateur professionnel.
E
E
co
co
Transport Systems
Transport Systems
E
-CART
Kayak Carrier
X
-BARS
Aero Style Crossbars
E
co
E
co
MALONE
Transport Systems
Transport Systems
DownLoader
DownLoader
J-STYLE FOLDING KAYAK CARRIER
To Begin:
inside one of the Rubber Sleeves. With the Tubes con
Load Straps
Jawz Universal Adapters
bolt holes of the Rubber Sleeve with the Tube assemb
1A
Début : Raccorder ensemble les tubes inférieurs et s
insérant dans les manchons en caoutchouc. Alignez e
boulon des manchons avec ceux des tubes (Figures 1
Base Pad
Covers
R
R
ack
ack
TM
TM
R
ack
R
Steel Plate
ack
70mm
Slide/Push the Upper and Lower Tube sect
60mm
Mounting Bolts
. Prior to installation, insert a bolt into the mounting holes in
the bottom of the carriers. Push upward to open the two
mounting hole covers located in the Base pads.
. Insert a Mounting Bolt into one mounting hole from the top
side. Rotate and close the mounting hole cover.
See image 1.
. Insérez un boulon de fixation dans l'un des trous hexagonaux
situés sur le côté supérieur du support.
(Figure 1)
2
TM
TM
TM
TM
R
Rubber Sleeve
TM
Mounting Bolt Washers
T-Knobs
2
2018
2018
ER509
ER218
Load Stra
12' Safety Lines

Publicité

loading

Sommaire des Matières pour EcoRack X-BARS

  • Page 1 . Insert a Mounting Bolt into one mounting hole from the top You must read and understand all of the instructions and cautions supplied with your EcoRack products(s) prior to installation or use. If you do not side. Rotate and close the mounting hole cover.
  • Page 3 -BARS Aero Style Crossbars Transport Systems Transport Systems Assembly & Use Instructions - Please Read Before Beginning FOR USE WITH VEHICLES EQUIPPED WITH TWO ROOF TOP CROSS BARS INSTRUCTIONS D’ASSEMBLAGE ET D’UTILISATION – À LIRE AVANT DE COMMENCER CONÇU POUR UNE UTILISATION SUR DES VÉHICULES AVEC DEUX BARRES TRANSVERSALES SUR LE TOIT 1).
  • Page 4 3). Lift the forward section of the tower to adjust FIG. 2 it’s position. Center towers over the raised side rails. See figure 2. 3). Soulever la partie avant du montant pour régler sa position. Centrer les montants sur les rails latéraux surélevés.
  • Page 5 . Obey all posed speed limits and traffic cautions. Adapt your driving for the load being transported. Regardless you should never exceed 65mph when transporting loads with this roof rack. . Do not use EcoRack cross bars for purposes other than what they were designed for.
  • Page 6: Disclaimer Of Liability

    If the original retail purchaser purchaser is unable to contact the EcoRack dealer, or the dealer is not able to remedy the defect, the original retail is unable to contact the Malone dealer, or the dealer is not able to remedy the defect, the original retail purchaser should purchaser should contact EcoRack by email at info@ecorack.net...
  • Page 7 à sa discrétion, un produit défectueux sans frais pour ce qui est des pièces et de la main-d’œuvre. EcoRack peut décider, à son choix, de ne pas réparer ou remplacer un workmanship by repairing or replacing, at its option, a defective product without charge for parts or labor.