Operations; Control Panel - Samsung WW10K64 Serie Manuel D'utilisation

Operations

Control panel

01 Cycle Selector
02 Display
03 Temp.
04 Rinse
05 Spin
06 Options
07 Bubble Soak
08 Delay End
WW10K6410QX_DC68-03676Y-00_EN.indd 29
02
Turn the dial to select a cycle.
The display shows current cycle information and estimated time
remaining, or an information code when a problem occurs.
Press to change the water temperature for the current cycle.
Press to change the rinse count for the current cycle. You can set the
rinse count to a max of 5, depending on the cycle.
Press to change the spinning speed for the current cycle.
• Rinse Hold ( ): The final rinse process is suspended so that the
laundry remains in the water. To unload the laundry, run a drain
or spin process.
• No Spin : The drum does not spin after the final drain process.
• Spin Only : To run the Spin Only cycle, press Spin for 3 seconds.
When the cycle time and spinning speed appear, press Spin
repeatedly until a desired spinning speed is selected. Then, press
Start/Pause to start the cycle. The spinning time depends on the
selected cycle.
Press to select an option from Intensive and Pre Wash.
Press again to deselect.
• Availability of the options depends on the cycle.
Press to activate/deactivate the Bubble Soak function. This function
helps remove a wide variety of stubborn stains.
Delay End lets you set the end time of the current cycle. Based
on your settings, the start time of the cycle will be determined
by the machine's internal logic. For example, this setting is useful
for programming your machine to finish a wash at the time you
normally return home from work.
• Press to choose a preset unit of hours.
03 04
05
06
10
08
11
09
07
English 29
2017/5/16 10:49:24