IMPERIAL KITCHEN VENTILATION Slim Line N1900 Mode D'emploi page 5

Installation Instructions for 1900-10 ONLY
1. From bottom of hood, measure 10" up and draw a line.
2. Take "U" shape installation bracket and line the bottom of the bracket
up with the line (center bracket left to right) install bracket using #10 x
2-1/2" wood screws, if you have wood to screw in to. If not use the
3/16" x 3" toggle bolts.
3. Lift up hood and connect hood brackets to installation bracket using
4. (8) 10-32 Hex Keps nuts and (8) 10-32 x 3/4 screws. Make sure hood
is level before you tighten all screws.
5. Use (2) 3/16" x 3" toggle bolts or #10 x 2-1/2" wood screws and (2)
1-1/4" OD Fender washers to secure to back of wall.
6. To install DUCT COVER—remove brown tape from brackets and line
up duct cover to the brackets on top of hood.
Wall Mounting application.
Top
Brackets