Hydroworks 8489106 Manuel D'instruction page 2

DIMENSIONAL DIAGRAM AND WIRING INSTRUCTIONS
NOTE: All the sizes mentioned in Fig. 1, 2 & 3 are in inches
Retracted Length
.98" 4.17"
.51"
.98"
.55"
3.78" 4.65"
15.75"
Fig. 1
WIRING DRAWING
Fig. 4
12V DC LINEAR ACTUATOR
INSTRUCTIONS MANUAL
Storke
.93"
.51"
.39"
Fig. 2
Red
Black
Fig. 3
2 OF 3
INSTALLATION
WARNING: Do not exceed the rated load capacity of the linear actuator.
Please ensure the linear actuator shaft is fully "retracted". The term "retracted" in this manual refers to the position
in which there is no further movement towards the DC motor while the actuator is powered on. (Please refer to
3.03"
Fig. 5 below).
Base End Mounting Hole
2. The shaft and base end mounting holes of the linear actuator should be installed into 2 mounting brackets.
Locations for these mounting brackets should be chosen according to the stroke length of the linear actuator.
Caution
must be taken to ensure that the two-way movement of the linear actuator is smooth and
unobstructed and no twisting or binding will occur.
3. After the mounting position has been selected remove and install the mountings brackets.
4. Place the linear actuator back in the brackets and install the pins/bolts through the shaft and base end
mounting holes. Lubricate the pins/bolts and make sure that they are not sticking or binding.
5. The linear actuator should be installed in the horizontal position if it is going to be operated in that direction
and likewise for the vertical position.
6. Connect the linear actuator to the power source according to the instructions on page 2.
7. The linear actuator should be tested after it's installation is complete to ensure that:
• It's travel distance is meeting the requirements of the application
• The motor should stop when the shaft reaches the end of it's stroke when extending and retracting
8.The installation is complete when all the above criteria are met
MAINTENANCE
1. Store the linear actuator in a dry place and out of direct sunlight.
2. Clean the linear actuator with a dry cloth.
12V DC LINEAR ACTUATOR
INSTRUCTIONS MANUAL
Shaft
Shaft Mounting Hole
(Fully Retracted)
DC Motor
Red
Black
Fig. 5
3 OF 3