KlikAanKlikUit Trust SMART Home ZSDR-850 Mode D'emploi page 4

EN ZSDR-850 ZIGBEE SMOKE DETECTOR
COMPATIBILITY
This photoelectric smoke detector works with the Z1 Zigbee Bridge
and the ICS-2000 to give additional functionality like receiving
push notifications when smoke is detected. NOTE: For receiving
push notifications, a fully working internet connection is required.
PLACING THE SMOKE DETECTOR
• Place the detector on the ceiling. In case of a sloped ceiling, place
90 cm from the highest point.
• To ensure that the sound can be clearly heard in bedrooms, the
smoke detector must be placed no further than 3 meters from a
bedroom door.
• It is recommended to install a smoke detector on every floor of
your home
• Place the detector at least 2m away from cooking appliances
• Relocate the unit if it produces frequent false alarms
• Do not place the smoke detector near exhaust fans or air-
conditioning systems as they can prevent smoke from reaching
the smoke detector
• Avoid placing the detector in bathrooms and other very humid
or dusty places
• Always comply with the local regulations for installation in
buildings.
6
ZSDR-850 ZIGBEE SMOKE DETECTOR EN
TESTING AND USAGE
• Always test the detector using the test mode after placement
and after that once a week.
• Test the detector once a week. Replace the detector immediately
when the test fails.
• Replace the battery immediately when the detector is indicating
battery low. (up to 3-year battery life)
• Clean the detector once a month with a soft brush
• Never use water, cleaners or solvents to clean the detector since
they may damage the unit.
• If the detector is damaged replace it immediately.
• The smoke detector will not alert hearing impaired residents. It is
recommended to install special smoke detectors to alert hearing
impaired residents.
• Never use an open flame of any kind to test this unit. You might
accidentally damage or set fire to the unit or to your home.
• Use only a CR123A 3.0V Lithium Battery. Other batteries may
cause unreliable operation.
• Removal of the battery will render this alarm inoperative
• Press test button to check operation after replacing the battery.
Check www.trust.com/71197 for the latest instructions
7