Publicité
Les langues disponibles
Les langues disponibles
6.
Begin removing front panel assembly by opening door and
removing the two (2) screws shown in Figure 5.
NOTE: After removal of these screws, close door.
(2) SCREWS
7.
Disconnect door switch connector located on top right front
side of dryer. See Figure 4.
8.
Remove four (4) screws from bottom of front panel as shown
in Figure 6.
FRONT PaNEL
9.
Remove the three (3) screws from the top of the front panel
as shown in Figure 7.
(3) SCREWS
10. Remove front panel assembly from dryer by lifting front panel
assembly off tabs (one each side).See Figure 8.
(1 OF 2) TaBS
DRyER DOOR
figure 5
(4) SCREWS
figure 6
figure 7
figure 8
11. Remove the bulkhead assembly from dryer by first removing
lint screen from dryer lint duct. See Figure 9.
FRONT
BulkHeaD
PaNEL
aSSEMBLy
12. Disconnect moisture sensor disconnect block from main
harness disconnect block located at lower right side of dryer.
See Figure 10.
13. Remove lint duct by removing four (4) screws and clip as
shown in Figure 11.
NOTE: Slide lint duct down and away from dryer to remove.
FRONT
PaNEL
— 2 —
LINT
SCREEN
figure 9
MOISTuRE
SENSOR
DISCONNECT
BLOCK
maiN HaRNeSS
DISCONNECT
figure 10
(3) SCREWS
SCREW
figure 11
LINT
DuCT
BLOCK
LINT DuCT
CLIP
(continued)
W10609999 A
Publicité
