Test Instructions - Overmax AD-02 Manuel De L'utilisateur

Rear cover
Folded
mouthpiece

2. Test instructions

2.1. Use the Power button to turn the breathalyzer on.
2.2. Breathalyzer turns on and emits a short beep. The „PH" message
is shown on the screen for a brief moment. Then, it is displaced by
a countdown timer that shows the test preparation time. Please wait.
After 20 seconds the device beeps and the screen shows „BLOW"
message. Now you can start the test.
2.3. The first step is to take a deep breath, then blow directly into
the mouthpiece's hole until you hear a beep sound.
2.4. When the test is completed the device beeps, and the result
is displayed on the LCD screen. The alarm is off as long as the
concentration of alcohol in breath is lower than the present level.
However, when it is exceeded, the device emits long beep sound
and the red warning LED turns on. The test result is displayed on
the screen for 35 seconds, then the device turns off.
2.5. If you need to do the test again, please repeat the steps described
in sections 2.2 - 2.4.
AAA1.5V alkaline
batteries
Unfolded
mouthpiece
EN