Hama 00062723 Mode D'emploi page 7

7. Select "Install the software automatically
(recommended)", and click Next.
8. To complete the installation, click Finish.
4. Confi guration
By default, the USB GPS receiver using the following
settings:
COM port: COM3
Transfer speed: 115200 baud/s
In order for the navigation program to be able to
communicate with the GPS receiver, the respective COM
port and the transfer speed must be set in the navigation
software. For further information on this, refer to the
navigation software manual.
6
All manuals and user guides at all-guides.com
If your navigation program does not support the COM
port used by default, you can manually change the COM
port.
Proceed as follows:
1. Open the Device Manager.
2. Select "CP2101 USB to UART Bridge Controller
(COM3)" under Ports (COM and LPT), and open the
device properties by double-clicking.