Nowsonic AUTARK OD09 Mode D'emploi page 8

Nowsonic Autark OD09
GB
User manual
NOTE:
When you tap one of the touch sensitive buttons, the
lights of Autark OD 09 are immediately dimmed in order to protect
your eyes and to enhance visibility. When the operation is finished,
the LED s reach full brightness after a few seconds.
All manuals and user guides at all-guides.com
4.
This switch toggles Autark
Autark
In order to operate Autark
on the unit with this switch without connecting the supplied power
cable to the mains supply. The charging capacity of the battery is
displayed on the battery charging indicator (2).
5. Power connector
The supplied
the supplied mains cable. If it gets lost, please contact the dealer from
whom you have purchased your Autark unit.
6.
This connector allows to feed an external
Autark
another Autark unit. In both cases, the Autark unit must be configured
as a slave device via the menu.
7.
This valve permanently vents the housing of the Autark
no heat accumulation occurs.
8
SWITCH
OD09
OD09 will only be charged when the unit is switched on.
OD09
mains adapter is plugged to this connector. Use only
CEE
socket
DMX IN
can be controlled from an external
OD09
VALVE
NOTE:
Please make sure that the valve isn't blocked or covered, so
that an appropriate ventilation is guaranteed.
www.nowsonic.com
on and off. The internal battery of
with the internal battery pack, turn
signal to Autark
DMX OD09
controller or
DMX
, so that
OD09
.