Technical Data - camry Premium CR 1259 Mode D'emploi

18. Always use caution when boiling water in the kettle. Do not touch the housing of kettle
or lid. Do not open the lid during boiling in kettle or immediately after boiling, because
steam coming out of lid can cause burns.
19. Move the kettle only by holding it by handle..
20. Never fill kettle above MAX level and below 2,5l level. It may cause damage of kettle.
21. Never switch on kettle without water.
22. Never use kettle with open cover (automatic shutdown will not work).
23. Descale your boiler regularly. Using boiler with heating element covered by scale may
cause damage.
24. Do not use aggressive detergents to wash the boiler housing - they can damage the
boiler or remove the markings.
25. The device is not designed to work with external schedulers or separate remote control
system.
26. Children aged 3 to 8 years old can enable and disable the device only when it is in its
normal position of use, they are supervised or instructed on the safe use and understand
the resulting risks. Children aged 3 to 8 years old can not connect device, operate, clean
or maintain.
27. Before first use, remove all packaging components. Attention! In the case of a casing
with metal parts, on these elements a slightly visible protective foil can be stretched, which
should also be removed.
28. NEVER cover the device during operation or when it does not cool down completely,
remember that the heating elements of the device take time to cool down completely.
DESCRIPTION
1 - housing
4 - the lid
USING THE ELECTRIC KETTLE
BEFORE FIRST USE: Fill up the kettle with water, boil and pour. Repeat three times. To remove possible scent of manufactory, please
boil few times water.
1. Fill the boiler with water. Make sure that heating plate is fully immersed in water.
2. Place the appliance on the flat, even and heat resistant surface.
3. Plug the boiler to the 220-240v ~50/60Hz mains, press ON/OFF switch. Indicator lamp will light.
4. When the water reaches 97degrees termostat starts to keep water on the same temperature level.
5. When in boiler will be less than 2,5l water, switch off the boiler.
6. During boiling water the lid have to be closed.
7. After boiling, time demanded for the thermostat to be ready is 10 minutes. After this time kettle can be switched on again.
8. Switching empty boiler, or with insufficient level of water, will cause automate switching off the kettle. Wait till cool down the kettle,
pour enough water and after few minutes switch the boiler on.
9. Do not leave working boiler without unattended.
10. The boiler is an electrical device and it is not designed to hold water or other liquids. After boiling, the water must be immediately
pour into another bowl. The water in the kettle after boiling can not stay longer than 10 minutes. Before each use, fill the kettle with fresh
water above the minimum and below the maximum level.
The device is equipped with a thermal switch. If the device is switched on and does not heat should reset the lever in the bottom. During
the reset, the unit must be connected to the power supply but the need to cool down.
CLEANING OF MAINTENANCE
Regularly descale the kettle. Descaling doesn't belong to guarantee service. Lack of regular descaling causes damage of the elements
of the appliance and cancels warranty of the product. Use descaling mixture to descale the kettle.

TECHNICAL DATA:

Capacity max: 20l min: 2,5l
Voltage: 220-240V ~50/60Hz
Power : 1650W
To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding waste bins.
Used appliance should be delivered to the dedicated collecting points due to hazarsous components, which may effect the
environment. Do not dispose this appliance in the common waste bin.
ALLGEMEINE SICHERHEITSVORSCHRIFTEN LESEN SIE AUFMERKSAM WICHTIGE
ANWEISUNGEN BEZÜGLICH DER SICHERHEIT DER BENUTZUNG BEWAHREN SIE
2 - ON / OFF switch
5 - handle
DEUTSCH
DEUTSCH
3 - indicator lamp
6 - lid lock
4
7 - tap