Install Handle; Grease Bucket - Camp Chef SMOKEPRO PG24SE-2 Instructions

3. Assemble the wire shelf to the legs as shown in Fig 2 using
Qty (4) M6 x 45 Bolts, Qty (4) M6 Flat Washers, Qty (4) M6
Lock Washers, and Qty (4) M6 Nuts. Finger tighten hardware.
M6 FLAT WASHER
M6 LOCK WASHER
M6 NUT
4. Assemble Qty (2) Wheels to the legs as shown in Fig 3 using
Qty (2) Wheel Axles, Qty (2) M8 Flat Washers, and Qty (2) M8
Nyloc Nuts. Tighten axle hardware with a wrench.
FIG. 3
5. With the help of another person, stand the grill upright. Be
careful as the lid on the hopper and grill will close as the grill
is stood upright.
6. Tighten all hardware assembled in the previous steps. Do not
crush the tubes by over tightening the hardware.
ATTACH CHIMNEY AND CHIMNEY CAP
1. Install chimney to grill as shown in Fig 4. Make sure to install
the gasket between the grill and the chimney.
2. Tighten all hardware.
3. Install M6 x 76 Bolt through chimney cap and secure using Qty
(1) M6 nut. Thread second nut onto bolt leaving approximately
1.5" to the top of the cap. Thread cap assembly down into the
chimney bracket until the lower nut hits the bracket. See Fig 4.
4. The height of the chimney cap can be adjusted for summer and
winter. In the summer the gap should be approximately 1-1/2".
In the winter the gap should be approximately ½".
5. Tighten all hardware.
M6 X 45 BOLT
FIG. 2
M6 NUT
M6 LOCK WASHER
M6 FLAT WASHER
M6 X 45 BOLT
WHEEL AXLE
M8 FLAT WASHER
M8 NYLOC NUT
FIG. 4

INSTALL HANDLE

1.Install the handle as shown in Fig 5.
2. Tighten all hardware.
PG24LS-6 (1)
HANDLE

GREASE BUCKET

1.Hang grease bucket from tube as shown in Fig 6.
FIG. 6
INSTALL DEFLECTOR AND DRIP TRAY
1. Install the Heat Deflector and Drip Tray as shown in Fig 7
and Fig 8.
FIG. 5
M6 FLAT WASHER (2)
M6 LOCK WASHER (2)
M6 NUT (2)
GREASE BUCKET