Ibiza LMH250WH Manuel D'utilisation page 4

next fixture consisting of a (male) 3 pin connector.
3. Then, proceed to connect from the output as stated above to the input of the following fixture and so on.
Master/Slave Fixture Linking
1. Connect the (male) 3 pin connecter side of the DMX cable to the output (female) 3 pin connecter of the first
fixture.
2. Connect the end of the cable coming from the first fixture which will have a (female) 3 pin connecter to the input
connecter of the next fixture consisting of a (male) 3 pin connecter. Then, proceed to connect from the output as
stated above to the input of the following fixture and so on
Mounting
ORIENTATION
This fixture may be mounted in any position provided there is adequate
room for ventilation.
RIGGING
The LED moving head provides a unique mounting bracket assembly
that integrates the bottom of the base, the included 'omega bracket'
and the safety cable rigging point in one unit (see the illustration on the
right).When mounting this fixture on a truss, be sure to use an
appropriate clamp with the included omega bracket using a M10 screw
fitted through the center hole of the 'omega bracket'. As an added
safety measure, be sure to attach at least one properly rated safety
cable to the fixture using one of the safety cable rigging points
integrated in the base assembly.
When selecting installation location, take into consideration lamp
replacement access and routine maintenance.
Safety cables must always be used. Never mount in places where the fixture will be exposed to rain, high humidity,
extreme temperature changes or restricted ventilation.
DMX Channel Table
6CH
CH Value
1 0-255
2 0-255
3 0-255
4 0-255
5 0-255
6 0-255
©Copyright LOTRONIC 2015
Function
PAN 0-540º
Tilt 0-220º
Pan &Tilt Speed (from fast to slow )
Dimmer 0-100%
Strobe in the line(from slow to fast )
LMH250WH-MINI
Often, the set up for Master-Slave and Stand-alone
operation requires that the first fixture in the chain
be initialized for this purpose via either settings in
the control panel or DIP-switches. Secondarily, the
fixtures that follow may also require a slave setting.
Please consult the '' Operating Instructions» section
in this manual for complete instructions for this type
of setup and configuration.
Page 4