Télécharger Imprimer la page

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

Stax Pro2 Kayak Carrier
Installation & Loading Instructions - Please Read Before Beginning
1
Cogs
. Insert a 100mm bolt into the square
Kayak Carriers
hole located in the top of the base.
Installation & Loading Instructions - Please Read Before Beginning
See image 2.
Veuillez lire les instructions avant d'entreprendre l'installation et le chargement
IMPORTANT WARNING: All vehicular transports are potentially hazardous. Any person(s) using Malone products are personally responsible for
following the given directions for use and/or installation and accepts full responsibility for any and all damages or injury of any kind including death,
1
3
which may result from their use and/or installation.
It is critical that all Malone racks and accessories be properly and securely attached to your vehicle. Improper attachment could result in a serious
accident, and could cause serious bodily injury or death to you or to others. You are responsible for securing the racks and accessories to your car,
checking the attachment's prior to use, and periodically inspecting the products for adjustment, wear, and damage.
You must read and understand all of the instructions and cautions supplied with your Malone products(s) prior to installation or use. If you do not
understand all of the instructions and cautions, or, if you have no mechanical experience and are not thoroughly familiar with the installation
procedures, you should have the product installed by a professional installer.
MISE EN GARDE IMPORTANTE: Tout transport d'un chargement sur le toit d'un véhicule est potentiellement dangereux. Une personne qui
utilise les produits Malone doit suivre sans faute les instructions d'installation et d'utilisation fournies et assume l'entière responsabilité pour tout
dommage ou toute blessure, y compris un décès, pouvant résulter d'une telle installation ou utilisation.
Il est essentiel de fixer correctement et solidement les supports et les accessoires à votre véhicule. Une mauvaise installation ou attache pourrait
provoquer un accident, entraîner des blessures corporelles graves à vous et aux autres et même causer la mort. Vous avez la responsabilité de
fixer solidement les supports et les accessoires à votre véhicule, de vérifier l'installation avant l'utilisation et d'inspecter périodiquement le produit
pour déceler tout signe d'usure ou de dommage ou tout problème d'ajustement.
Vous devez lire et comprendre les instructions et les mises en garde fournies avec les produits Malone avant l'installation et l'utilisation. Si vous
. Insert Mounting Bolt through one hole of a Jawz adapter.
ne comprenez pas les instructions et les mises en garde ou si vous ne possédez pas d'expérience en mécanique et ne connaissez pas à fond les
Insert washer and loosely apply a T-knob. See image 2.
procédures à suivre d'installation, vous devriez faire monter et poser le produit par un installateur professionnel.
MALONE
MALONE
S
TA
TWO KAYAK VERTICAL FOLD-DOWN CARRIER
Red Load Straps
Jawz Adapters
MALONE
DownLoader
DownLoader
J-STYLE FOLDING KAYAK CARRIER
Load Straps
Jawz Universal Adapters
Base Pad
Covers
P
2
X
R
O
50mm
40mm
Mounting Bolts
Foam Blocks
Step 1: Assembling the Stax Pro2
. Insert the bottom of the post into the
top of the base. Position so the cogs
on the post are in contact with the
cogs on the base. See image 1.
2
70mm
60mm
Mounting Bolts
. Prior to installation, insert a bolt into the mounting holes in
the bottom of the carriers. Push upward to open the two
mounting hole covers located in the Base pads.
. Insert a Mounting Bolt into one mounting hole from the top
. With the holes in the base and post aligned,
side. Rotate and close the mounting hole cover.
See image 1.
push the bolt through the two assemblies
until the end of the bolt is exposed.
. Insérez un boulon de fixation dans l'un des trous hexagonaux
Note: Confirm that the head of the bolt is
situés sur le côté supérieur du support.
(Figure 1)
fully seated into the base. See image 3.
2
R
R
TM
TM
9' Safety Strap
TM
R
TM
Mounting Bolt Washers
T-Knobs
MPG115
12' Tie-Downs
12' Safety Lines

Publicité

loading

Sommaire des Matières pour MALONE Stax Pro2

  • Page 10 Instructions de montage et de chargement – À lire avant de commencer Step 1: Assembling the Stax Pro2 Étape 1 : Assemblage du Stax Pro2 . Insert the bottom of the post into the top of the base. Position so the cogs Cogs Insérer le bas de la tige au haut de la base.
  • Page 11 MALONE Instructions de montage et de chargement – MPG115MD Stax Pro2 Installer une roulette noire de serrage au bout du boulon qui dépasse. Voir image 4. Étape 2. Installation des supports aux barres transversales. Desserrer la roulette de serrage et placer le support en position rabattue.
  • Page 12 MALONE Instructions de montage et de chargement – MPG115MD Stax Pro2 Insérer un boulon de fixation dans le trou hexagonal arrière et dans le trou de l’adaptateur Jawz. Voir image 8. Visser un bouton en T et serrer modérément jusqu’à ce que le support soit bien fixé à la barre.
  • Page 13 MALONE LONE Installation & Loading Instructions - MPG115MD Stax Pro2 En tenant la boucle d’une main et l’extrémité libre . Place the strap loops parallel to the carriers with the front strap loop on the windshield de l’autre, lancer ou projeter la sangle par-dessus le kayak et autour de la tige Stax.
  • Page 14 MALONE Instructions de montage et de chargement – MPG115MD Stax Pro2 Installer la sangle de sécurité bleue au centre des deux kayaks. Pour plus de facilité, tenir la boucle et lancer l’extrémité libre par-dessus les deux kayaks. Faire passer l’extrémité libre sous les kayaks et ramener vers le haut pour l’insérer...
  • Page 15: Attacher La Corde Au Véhicule Et À L'embarcation (Étapes E À O)

    MALONE, 81 County Road, Westbrook, Maine USA 04092 MALONE AUTO RACKS 81 County Rd. Ste 1, Westbrook, ME 04092 Courriel : sales@maloneautoracks.com P: 207.774.9100 F: 207.615.0551 Web: www.maloneautoracks.com E: support@maloneautoracks.com W: www.maloneautoracks.com...
  • Page 16: Exonération De Responsabilité

    Mexique. Si le produit semble défectueux, l’acheteur original doit contacter le détaillant Malone où il a fait son achat et celui-ci lui fournira des renseignements sur la démarche à suivre. Si l’acheteur original ne réussit pas à contacter le détaillant Malone ou encore si le détaillant est incapable de remédier à...

Ce manuel est également adapté pour:

Mpg115