Festo PEV-1/4-B-M12 Notice D'utilisation page 15

PEV-1/4-B-M12
Setting the hysteresis:
6. Apply the upper switching pressure po to
the PEV-... (lower switching pressure pu
plus desired hysteresis Hy [see diagram in
Fig. 10]).
The display remains unchanged.
7. Turn the adjusting bolt 5 (A/F11) in an
anti-clockwise direction until the PEV-...
switches (upper switching pressure re-
ached). The lower switching point remains
almost unchanged.
The continuity tester shows a reduced
voltage flow.
Modifying the switching point:
8. If the switching point must be modified, repeat the following steps until the
desired upper and lower switching points are set:
– first apply the lower switching pressure and turn adjusting screw 7 then
– apply the upper switching pressure and turn adjusting bolt 5.
In this way, you can specify the switching point and the hysteresis in steps.
9. Replace the protective cap 6.
Festo 0005NH– English
Fig. 10
Fig. 11
5
15