Symbols Used To Mark Instructions; Important Safety Instructions - Wilhelmsen Ships UNTIOR HPC 54/1 Manuel D'instructions

UNITOR HPC 54/1 67/1
Symbols used to mark
instructions

1 Important safety instructions

For your own safety
The high-pressure cleaner may
only be used by persons in-
structed in its use and who have
been expressly authorised to do
so.
Although extremely easy to op-
erate, children should not be al-
lowed to use the cleaner.
General
Use of the high-pressure clean-
er is subject to the applicable lo-
cal regulations.
Besides the operating instruc-
tions and the binding accident
prevention regulations valid in
the country of use, observe rec-
ognised regulations for safety
and proper use.
Do not use any unsafe work
techniques.
4
All manuals and user guides at all-guides.com
Safety instructions in these
operating instructions
must be observed to prevent
risks to persons are marked with
this danger symbol.
Before starting up your high-
pressure washer for the first
time, this instruction manual
must be read through carefully.
Save the instructions for later
use.
Transport
Transport of the high-pressure
cleaner is easy on its large
wheels.
For safe transport in and on ve-
hicles we recommend to prevent
the equipment from sliding and
tilting by fixing it with belts.
For transport at temperatures
around or below 0°C, anti-freeze
should be drawn into the pump
beforehand (see chapter 6).
Before starting the cleaner
If your 3-phase cleaner was
supplied without a plug, have
it fitted with a suitable 3-phase
plug with earth conductor, by an
electrician.
Before use, check that the high-
pressure cleaner is safe and in
proper condition.
Regularly check whether the
power cord is damaged or
shows signs of ageing.
This indicates tips and instruc-
which tions to simplify work and to en-
sure safe operation.
This symbol is used to mark
safety instructions that must be
observed to prevent damage
to the machine and its perfor-
mance.
Use the high-pressure cleaner
only when the mains power lead
is in a safe condition. (risk of
electric shock if damaged!).
Check the rated voltage of the
high-pressure cleaner before
connecting it to the mains power
supply. Ensure that the voltage
shown on the rating plate corre-
sponds to the voltage of the lo-
cal mains power supply.
We strongly recommend that the
power supply to the high pres-
sure cleaner be connected via a
residual current circuit breaker.
This device stops the supply of
electricity if the leakage current
to earth exceeds 30 mA for 30
ms or it has an earth tester cir-
cuit.
Operate the cleaner only in an
upright position!
Please observe the regulations
and provisions applicable in
your country. Before putting the
high-pressure cleaner into ser-
vice, carry out a visual check of
all the major components.
Options / model variants
1)
Original instructions