NOMA 151-5596-2 Manuel D'instructions page 3

Use and care instructions
a) Before using or reusing, inspect product carefully. Discard any products that have cut, damaged,
or frayed wire insulation or cords, cracks in the bulb holders or enclosures, loose connections,
or exposed copper wire.
b) When storing the product, carefully remove the product from wherever it is placed to avoid any
undue strain or stress on the product conductors, connections, and wires.
USER SERVICING INSTRUCTIONS
To Replace a Fuse:
Power cord fuse replacement (1 replaceable 3 A, 125 V fuse is located in the plastic bag):
1. Grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling on cord.
2. Open fuse cover by sliding the fuse cover towards the blades of the attachment plug.
3. Turn the fuseholder over or push on the fuse for removal.
4. Risk of fire. Replace fuse only with 3 A, 125 V fuse.
5. Insert spare replacement fuse. Close fuse cover by sliding fuse access cover
towards the cord.
CAUTION:
To reduce risk of fire, replace fuse in power cord with only 3 A, 125 V fuse.
Do not replace attachment plug. Contains a safety device (fuse) that shall not be removed.
Discard product if the attachment plug is damaged.
To Replace a Bulb:
1. Grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling on cord.
2. Unlock the burned out LED bulb by lifting the hook.
3. Pull bulb and plastic base straight out of bulb holder.
4. Replace bulb with only 3.0 Volt, 20 mA push-in type LED bulb (provided with product). Always
match the hook to the tab.
5. Lock the hook of bulb base by pushing lock down into the tab.
Unlock
If the bulb base of the replacement bulb does not fit in the string: (as shown below by the Figs.)
a) Pull the reflector out.
b) Straighten the two wires on the end of the original burned-out bulb and remove the bulb base.
c) Straighten the wires on the end of the new bulb and remove
the bulb base.
d) Guide the two wires of the new bulb into the two holes of the original
bulb base and bend the wires back (always match the long lead of new
bulb to the hook on bulb base).
e) Insert the reflector into the base.
Connecting Sets End to End (for connect multiple products)
When multiple products are connected together, do not exceed the lowest of the indicated maximum wattage
on the cord tag near the connected product's receptacle.
All manuals and user guides at all-guides.com
Hook
Tab
Lock