Centrometal CSK-Touch Instructions Techniques page 24

All manuals and user guides at all-guides.com
Example of installation of wireless and wired connection of corrector with CM2K module:
1.
insulating part
a Power connectors
It is necessary to remove the insulating part of the wire and insert the conductor
part into the connectors.
F - Phase
N - Zero
b A connector for wired connecting the module CM2K
D.COR1
Image: connecting a two-wire cable
24
2.
conductive part
a
F N
Image: power connection (230V)
D.COR2
For wired connection, it is not important
which output each individual corrector is
connected to (D.COR1 or D.COR2), but pay
attention to have the corrector terminal ''+''
connected to the CM2K terminal ''+'' and
vice versa, to have the corrector terminal ''-''
connected to the CM2K terminal ''-''.
the place of the two-wire
communication cable
Technical instructions CSK-Touch
Installation
b
+ -
ENG