Azuni ST-05 Guide D'installation

For additional technical assistance or for any questions or concerns about your kitchen strainer's warranty, please contact us.
www.azuni.ca
IF YOU HAVE PURCHASED A STANDARD STRAINER, PLEASE MAKE SURE TO READ THESE INSTRUCTIONS CAREFULLY
1
Strainer
body
Foam
Place foam gasket and strainer body on
the top side of drain opening.
Alternatively Plumber's Putty could be
used instead of foam gasket.
4
Tail pipe
Tail pipe nut
Insert tail pipe with nut into home's
plumbing, then align and secure
tail pipe nut to strainer body.
1. Rinse the strainer with water.
2. Coat the strainer with baking soda, Flitz or Barkeepers friend.
3. With sponge, scrub strainer and all sink walls in the direction of
the steel grain.
4. Spray on undiluted vinegar.
AZUNI PRODUCTS
Products and specifications shown are subject to change without notice. Please contact our technical support at care@azuni.ca for any further queries, replacement parts requests, etc. ©2021 AZUNI ® all right reserved.
WARRANTY
www.azuni.ca/warranty
care@azuni.ca
2
Sink
Rubber
gasket
Outer
gasket
Basket nut
From underneath bring outer basket with
rubber gasket under the sink and secure
with basket nut.
5
Rubber
gasket
Tighten tail pipe nut to strainer body,
ensure the rubber gasket is present.
CARE AND CLEANING
azuniproducts
INSTALLATION GUIDE
ST-05
STANDARD STRAINER
3
Tighten basket nut using channel locks or
6
Basket
Run water and confirm no leaks.
5. Rinse again.
6. Buff with a few drops of olive oil.
7. If necessary, repeat procedure.
azuniproducts
+1-888-493-2931
TOLL
FREE
wrench.
azuniproducts