Quick Start Guide - nedis LTLGQ3M2 Serie Guide De Démarrage Rapide

a

Quick start guide

Desktop LED lamp
For more information see the extended manual online:
ned.is/ltlgq3m2xx
Intended use
The Nedis LTLGQ3M2xx is a desktop LED lamp with a built-in wireless
charger.
This product is intended for indoor use only.
The product is not intended for professional use.
Any modification of the product may have consequences for safety,
warranty and proper functioning.
Specifications
Product
Article number
Dimensions (l x w x h)
Weight
Power input
Power
LED lamp
Rated power
Max. illumination
Max. luminance
Light modes
Color temperature
Adapter
Power input
Power output
Power
Rated consumption power
Wireless charger
Power output
Power
Radio frequency range
Radio frequency power
Timer
LTLGQ3M2xx
Desktop LED lamp
LTLGQ3M2xx
600 x 170 x 170 mm
402 g
12 VDC ; 2.0 A
24 W
5.5 W
1000 Lux
350 lm
Natural, cool, warm
2700 - 6500 K
100 - 240 VAC; 50 - 60 Hz
12.0 VDC ; 2.0 A
24 W
21 W
9 V / 1.1 A
10 W
110 - 205 KHz
- 10.99 dBuA/m @ 10 m
Smart timer shutdown
Main parts (image A)
1
LED lamp
2
Power input
3
Power adapter
4
Wireless charging area
Safety instructions
-
WARNING
• Ensure you have fully read and understood the instructions in this
document before you install or use the product. Keep the
packaging and this document for future reference.
• Only use the product as described in this document.
• Do not use the product if a part is damaged or defective. Replace a
damaged or defective product immediately.
• Do not drop the product and avoid bumping.
• This product may only be serviced by a qualified technician for
maintenance to reduce the risk of electric shock.
• Do not expose the product to water or moisture.
• Disconnect the product from the power source and other
equipment if problems occur.
Installation
1. Plug the power adapter A
2. Plug the other end of A
Using the lamp
1. Press the power button A
6
2. Press and hold A to change the brightness of A
3. Press the light mode button A
light modes.
4 The light modes are Natural, Cool and Warm.
4. Press and hold the timer button A
1
4 flashes twice to indicate the timer is active.
A
1
4
switches off after the timer runs out.
A
6
5. Press A to switch off A
Using the wireless charger
1. Place your QI wireless charging enabled device onto the wireless
4
charging area A .
2. Check the charging indication on your device to ensure your
device is charging.
4
5
Light mode button
6
Power button
7
Timer button
3 2
into the power input A
3
into a power outlet.
6
to switch on the LED lamp A
1
5
to cycle through the different
7
to set a timer for 40 minutes.
1
.
.
1
.
.