Battery Pack And Charger - Alemite 575-A1 Guide D'exploitation

Cordless Grease Gun
Priming the Gun
In most cases the gun will prime simply by
operating the Trigger several times.
Should grease fail to appear, air must be bled.
Force Prime
This process manually assists air within the gun
to be bled at the Bleed Valve.
1. Pull the follower rod and engage the follower by
rotating the rod.
2. Depress Bleed Valve (47) and at the same time
push on the follower rod.
Once the air is eliminated, operate the gun
several times.
Once grease appears, disengage the follower rod
from the follower and push into the Grease
Cylinder.
Gun Operation
Battery Pack (36) is intentionally shipped with a
low charge.
Charge Battery Pack prior to use.
• Refer to the following section for details.
NOTE: The Battery Pack must be dis-
charged and recharged several times
before achieving a full charge.
CAUTION
Air pockets in the grease can cause the gun
to lose prime. Check for prime after each
refill and before lubrication.
Do not attempt to unblock a clogged
bearing, line, or grease fitting by continuing
to operate the gun. Release the Trigger
should the gun stall.
Damage to components can occur.
Check Valve Contamination
Should the gun fail, the outlet check may be held
open. Remove Plug (40), clean Ball (43), and the
Ball seat of Head (16).
Alemite, LLC

Battery Pack and Charger

This manual contains important safety and operating
instructions for the Battery Pack and Battery Charger.
Before usin g the Battery Ch arger read all
instructions and cautionary markings on Battery Charger
(54), Battery Pack (36), and products using the Battery
Pack.
To reduce the risk of injury, charge only Nickel-Cadmium
type rechargeable batteries. Other types of batteries may
burst causing injury.
An extension cord should not be used unless absolutely
necessary. Use of an improper extension cord could
result in a risk of fire and electric shock. If an extension
cord must be used, make sure it is 16-gauge. Check to
ensure that the pins on the plug of the extension cord
are the same number, size, and shape as those of the
plug on the Charger. Make sure that the extension cord
is properly wired and in good electrical condition.
Do not incinerate the Battery Pack, even if it is severely
damaged or completely worn out. The Battery Pack may
explode in fire.
Do not expose the Charger to rain, snow, or frost.
To reduce the risk of damage to electric plug and cord,
pull by the plug rather than the cord when
disconnecting the Charger.
Make sure the cord is located so that it will not be
stepped on, tripped over, or otherwise subjected to
damage or stress.
Do not operate the Charger with damaged cord or plug.
Replace immediately.
7
WARNING
CAUTION
Revision (4-13)
SER 575-A1