Replacing The Harness; Shut-Off Assembly Maintenance; Nozzle Maintenance - The Fountainhead Group 190679 Mode D'emploi

Replacing the Harness

1. For each side of the harness (K), remove the small
plastic clips (1) from the two shoulder strap loops
and thread each loop through the slots at the
top of the sprayer handle.
2. Replace the clips (1) through the loops and pull
the strap securing the two harness (K) straps in
place.
1
3. For the lower straps, remove the strap from the
top portion of the buckles (2) and place around
the foot stand (3), starting from underneath.
4. Loop the strap through the first section of
the buckle (2). Then loop the strap through
the other section of the buckle (2) to tighten.
Adjust the shoulder pads and strap lengths for a
comfortable fit.
2
5. The harness waist belt (H) is removable. The
lumbar support section of the harness (K) has
a pass-through, by which the waist belt can be
assembled or disassembled by pulling through -
The waist belt will be assembled to the harness
out of the box; so disassembly is just pulling it
from the main harness; assembling is feeding it
through the main harness.
K
3
K

Shut-Off Assembly Maintenance

WARNING: Prior to performing maintenance,
always depressurize the sprayer by turning the sprayer
OFF and squeezing the shut-off lever to spray until
liquid flow stops.
1. Unscrew the handle (1) from the shut-off
assembly (2).
2. Remove the filter (3).
3. Clean any debris from inside the handle (1),
shut-off assembly (2), or the filter (3) by rinsing
with cool, clean water.
4. Reassemble the components as shown and
tighten all connections securely.
1

Nozzle Maintenance

WARNING: Prior to performing maintenance,
always depressurize sprayer by ensuring the sprayer
is OFF and then squeezing the shut-off lever to spray
until liquid flow stops.
• If a nozzle clogs, remove and disassemble the
nozzle assembly.
• Clean the openings of any obstructions or residue.
• Do not use sharp tools that could scratch or
damage the nozzles as spray pattern could be
affected.
• Do not hit nozzle against surfaces to unclog.
H
ENGLISH
3 2
13