Software Update - Samsung HW-J250 Mode D'emploi

SOFTWARE UPDATE

Samsung may offer updates for the Soundbar's system
firmware in the future.
If an update is offered, you can update the firmware by
connecting a USB device with the firmware update
stored on it to the USB port on your Soundbar.
Note that if there are multiple update files, you must load
them onto the USB device singly and use them to
update the firmware one file at a time.
Please visit samsung.com or contact the Samsung call
center to receive more information about downloading
updates files.
The product has a DUAL BOOT function. If
●
the firmware fails to update, you can update
the firmware again.
Insert a USB device containing the firmware
●
update into the USB port on the main unit.
Updating firmware may not work properly if
●
audio files supported by the Soundbar are
stored in the USB storage device.
Do not disconnect the power or remove the
●
USB device while updates are being applied.
The main unit will turn off automatically after
completing the firmware update.
After the update, all settings are reset to their
●
factory default settings. We recommend you
write down your settings so that you can
easily reset them after the update.
If the firmware fails to update, we
recommend formatting the USB device in
FAT16 and trying again.
Once the software update is complete, turn
●
off the product and then press and hold the
( p ) button on the remote control for more
than 5 seconds. The Red
and the unit powers off. The upgrade is
complete.
Do not format the USB device in the NTFS
●
format. The Soundbar does not support the
NTFS file system.
Depending on the manufacturer, some USB
●
devices may not be supported.
21
FUNCTIONS
LED will blink