Heath Zenith 598-1116-10 Mode D'emploi page 8

3. Adjust RANGE Control. To increase sensitivity, turn the RANGE
control toward MAX. To decrease sensitivity, turn the RANGE
control toward MIN. Note: If the RANGE is set too high, false
triggering may result in some environments.
Note: When using test mode to check operation in the day time:
A. Set the DETECT control switch to DAY/NIGHT and
B. Set the ON-TIME control to TEST.
. Set ON-TIME Control. Determine the amount of time you want
the connected device to stay on after motion is detected (1 or
5 minutes). Slide the ON-TIME control to the corresponding
setting.
IMPORTANT: Avoid Aiming Control At:
• Objects that change temperature rapidly, such as heating vents,
fans, and air conditioners. These air sources could cause false
triggering.
• Areas where pets or traffic may trigger the control.
• Nearby large, light colored objects reflecting light may trigger the
shut-off feature. Do not point other lights at the sensor.
ON-TIME Control
RANGE
CODE DETECT ON-TIME
(MINUTES)
ON
DAY NIGHT
5 1 TEST
1 2 3 4 NIGHT ONLY
MIN MAX
Indoor Motion Sensor
Motion Sensor Controls
30 ft.
(9.1 m)
Maximum Range
Indoor Motion Sensor Coverage Area
All manuals and user guides at all-guides.com
Outdoor Motion Sensor
ON-TIME RANGE
(MINUTES) MAX MIN
5 1 TEST
LED
Indicator
Range Control
150°
Maximum
Coverage Angle
8 ft.
(2. m)
Maximum Range
Outdoor Motion Sensor Coverage Area
Motion
Sensor
Least Sensitive
The detector is most sensitive to motion across its field of view.
Indoor and Outdoor Motion Sensor Sensitivity
Aim Sensor Down
for Short Coverage
Adjusting Indoor Motion Sensor Coverage
Aim Sensor Down
for Short Coverage
Adjusting Outdoor Motion Sensor Coverage
8
70 ft.
(21 m)
Maximum
Coverage Angle
Motion
Sensor
Most Sensitive
Aim Sensor Higher
for Long Coverage
Aim Sensor Higher
for Long Coverage
598-1116-10
180°