Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
PART 1
Preparation
The following method is the standard installation. There may be some different cases depending on the structure
where the mounting bracket is placed or the shape and mounting condition of the wood hood. In such a case,
please arrange best possible way according to the condition of the place where the range hood is being installed.
WARNING!
• If the range hood is not installed properly, it could become detached and fall.
• Ensure that the metal duct does not touch other metal/housing materials, otherwise fire or electric shock could
result.
This range hood is designed to discharge upward from the unit, but may vent horizontal above the unit. For vertical
discharge, run duct work between the hood location and roof cap location.
To get the best result, use a minimum number of transitions and elbows. Be sure to attach a roof/wall cap to avoid
rain from entering the exhaust duct.
08E W
The range hood unit should be
mounted to a liner which has the
dimensions stated in diagram. Install
the liner securely after checking that
the opening size of the liner is the
same as the figure shown.
CAUTION
• The liner shape illustrated in this installation manual is only for reference.
• When the liner is installed in the wooden hood, the inside of the wooden hood placed above the cooking surface
must be fully covered by the metal barrier including bottom edges. Select a suitable liner and metal barrier
according to the size and shape of the wooden hood and install properly.
• The liner should be installed tightly. If the liner installation is not correct, the range hood unit may become
detached and fall.
Installation Instructions, Revised 02/11/14
Note: 2x 8" round
duct
Note: 2x 8" round
duct
Note: 2x 8" round
duct
08E P
Note: 2x 8" round
duct
3
Publicité
Table des Matières
