Replacing The Dvd Player - Dynex DX-LTDVD20 Guide De L'utilisateur

Maintaining

Replacing the DVD player

To remove the old DVD player:
1 Turn off your TV combo, then unplug the power cord.
2 Place cushioning, such as a towel, on a flat surface, then place your
TV combo face-down on the cushioning.
Caution
Your TV combo's screen can be easily damaged.
Make sure that you place cushioning between the
screen and the surface you are using as your work
area.
3 Remove the four screws (1).
4 Slide the DVD cover in the direction of the arrow (A).
5 Remove the four screws (2).
6 Disconnect the DVD player from the TV as shown in the
illustration.
7 Remove the DVD player.
1
DVD cover
1
2
2
DVD player
1
1
A
D
2
2
1
2
B
C
To install the new DVD player:
1 Insert the new DVD player in the direction of the arrow (C).
2 Reconnect the DVD player to the TV as shown in the illustration.
3 Replace the four screws (2).
4 Slide the DVD cover onto the DVD player in the direction of the
arrow (D).
5 Replace the four screws (1).
--ST3×12
--ST3×8
Disconnect player
23