Positioning The Shredder And Starting It Up - HP OneShred 8CC Mode D'emploi

EN
1 Manual operation (forward)
2 Automatic operation
3 Power OFF
4 Reverse operation

Positioning the Shredder and Starting It Up

The shredder only operates when the waste bin supplied is fitted. Do not position the shredder
near any sources of heat and maintain a distance of at least 10 cm to walls. This ensures the
shredder is sufficiently cooled.
1 Set the waste bin down on a stable, level, horizontal surface and in the vicinity of an easily
accessible power socket.
2 Mount the shredder attachment on the waste bin. The shredder attachment latches audibly in
place. If the shredder attachment is not fitted properly on the waste bin, the shredder cannot
be switched on.
Caution!
Risk of injury through sharp edge of cutting mechanism! The underside of the cutting
mechanism has sharp edges and corners. Only take hold of the cutting mechanism by the
grips.
Only use the power cable supplied.
3 Slide the main switch to OFF and connect the power plug to the power socket.
4 Slide the main switch to AUTO.
Î You have put the shredder into operation. The status indicator lights up blue.
1 2
FWD AUTO
overload
8 7
- 14 -
3 4
OFF REV
overheat
6 5
5 Overheating
6 Main switch
7 Overloading
8 Status indicator