Rear Camera Installation - Amazon D330GD Mode D'emploi

2. If the function and display are normal before installation, but abnormal
after installation, it is likely to cause problems during installation. Please
check whether there is a short circuit in the link line, or whether the pin
inserted in the link head is crooked and causes short circuit.
It is strictly forbidden to destroy or privately modify the original line in
the process of loading .If wire is damaged, you must replace a whole
set of new wire to install before power on.

◆ Rear camera installation

Step 1: Fix camera with 3M adhesive
Find a best location, tear off the 3M
adhesive on the rear camera, fix the rear
camera near by the car license plate lamp.
(if you need to adjust the angle, please
attach the rear camera bracket to the rear
camera and tighten it with screws first).
Step 3: Snake the cable
Use a trim removal tool to pop out tailgate
trim, then run the cable from outside of the
car into the trunk of your car.
GB
Step 2: Remove the Panel
Remove your trunk's interior panel to
expose the cars rear wiring chambers. Pop
open your trunk and look for a solid interior
panel covering the opposite side of your
license plate mounting area. Then,insert a
trim removal tool or other thin device
behind the panel and pry it off.
Step 4: Connect the rear cameras power
cable to the extension cable.
After snaking your rear camera's extension
cable, connect the power cable to your rear
camera's extension cord.
06