oneConcept Hopfengott Mode D'emploi page 34

EN
Further Settings
After the fourth step (at least 1 step) set is done, hold down the "STEP SET / START /
OFF" button for 3 seconds to START the operation.
You can see the "power", "target temperature" and "current temperature" and
"mashing" lights for each step flash in turn while boiling. After reaching the target
temperature, the target temperature and power of each step will flash in turn while
keeping warm, and the timer will begin to count down.
After you hear 9 beeps the machine will automatically proceed to S2, S3 and S4
if they have been set. If you hear one long beep after the last step, the machine will
automatically turn off and the display shows the actual temperature.
If you set the wrong data, you can hold down the "STEP SET / START / OFF" button for
3 seconds to turn OFF the machine to reset during a step operation, or unplug and plug
the machine in again to reset.
34