Ace 3003530 Mode D'emploi page 6

. To change the code, either:
• Add a jumper to the same location on both the sensor and the chime
or...
• Remove a jumper from the same location on both the sensor and the
chime or...
• Move a jumper on the sensor from one location to another. Move the corre-
sponding jumper on the chime to match the new location in the sensor.
Example: Move jumper at location "5" to location "" on both the sensor
and the chime.
Note: Jumpers in positions 1 through 7 must be exactly the same for both
the sensor and chime for this system to function.
Note: Unit will come factory set with jumpers in locations 5, 6, and 7 on the
sensor and on the chime.
The range of the wireless chime can vary with location, temperature, and
battery condition.
Inside
Sensor
ACE reserves the right to discontinue and to change specifications at any time without notice
®
without incurring any obligation to incorporate new features in previously sold products.
* Code Settings 1-7
Must Match Both
Sensor and Chime
Remove
screw to open
access door
Note: Some models might require the use of
tweezers to remove and replace the jumpers.
-6-
Back of Chime
598-1073-03