Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation
FAUCET ASSEMBLY/INSTALLATION
1 . Carefully take out all the parts of the faucet assembly . The faucet is
pre-assembled, except for the plate and the long washer .
2 . Take the washer, gasket and retaining ring off of the faucet body .
3 . Place the faucet body carefully through the middle hole in the plate,
long washer and sink . A second person may be required to hold the
body in place until the faucet installation is complete .
4 . From underneath, slide the gasket and washer and screw the
retaining ring over the end of the copper pipe and up to the exposed
threaded section of the faucet . Tighten the retaining ring by hand
until it is snug . Using a wrench or pliers, tighten the assembly .
5 . Gently tighten the two screws on the retaining ring .
Do not over tighten .
6 . Connect the water supply lines (not supplied) to the faucet .
All manuals and user guides at all-guides.com
6
Flexible neck
Faucet body
Plate
Gasket
Retaining ring
Screws
Sprayer
head
Faucet handle
Long washer
Washer
Threaded section
Publicité
Chapitres
Table des Matières
