Grandstream GSC3610 Guide D'installation Rapide page 4

Step 2:
Remove the top cover of the camera by turning it counterclockwise as
shown in the figure below. Refer to the arrow and small notch on the ma-
chine body as shown below to align the machine cover.
Step 3:
Place the cable into the groove of camera cover, mount the cover into
ceiling using provided screws as shown in below diagram. Leave the con-
nectors of cable dangling outside the cover.
Step 4:
Hold the body of camera and align to the notch as shown in the diagram,
then push the body of camera into the cover of camera already mounted
at the ceiling.
Wall
Ceiling
Ceiling
~3~
Step 5:
Rotate the body of camera to snap to the self-locking bracket.
GSC3610 CONFIGURATION
Following are the requirement to configure the GSC3610:
• Internet Browser like Firefox, Chrome, Microsoft Internet Explorer or
Edge.
• DHCP server enabled on the network.
Follow the steps below to access the GSC3610 WEB configuration page:
1. Download and install GS_Search tool from the link below:
http://www.grandstream.com/products/tools/surveillance/GS_Search.zip
2. Run the Grandstream GS_Search tool.
3. Click on button to start device detection.
4. The detected devices will appear in the output field as below.
Ceiling
~4~