Arexx IP-66 Mode D'emploi page 12

The Multilogger System consists of a logger loftware application, a
USB-, LAN-,WIFI- or GPRS receiver module and one or more sensors
TSN-XX, PRO-XX, IP-XX, each including a transmitter system.
A USB- or LAN cable connects the receiver to the computersystem or
to the LAN network. The Logger application can synchronize the sen-
sor data from several receivers.
E
For the multilogger system many different sensors are already availa-
ble. The sensors can measure temperature -200 to
N
humidity, Voltage and CO2
G
The multilogger application at the computer displays all sensor data,
L
which have been transferred by temperature sensors to the receiver.
I
Temperature sensors continuously registrate temperature and report
S
new values to the USB-, LAN-, WIFI- or GPRS receiver at intervalls of
ca. 45 seconds.
H
Each sensor in the sensorlist reports the date and time stamp for the
most recent measurement data set. The right side window displays a
continuous curve for the registrated temperature for the selected
sensor.
Sensors and receiver use a wireless communication system, working
at 433MHz. This frequency is freely available for communication at
transmitting powers under 10 milliwatts.
Depending on surrounding building constructions, the allowed 10mW
power level allows a transmission range of 20-40 meters inside
buildings, the open field range is much higher.
Temperature sensors may be located inside or outside buildings, at any
place where a registrated overview of temperature curves is desired.
Unreliable signal levels may be improved substantially by slightly
modifying the sensor's position or the receiver's location.
12
+400°C (PT-100),