Kichler 35206 Mode D'emploi page 11

ASSEMBLY INSTRUCTIONS
10
C
10.Remove two canopy screws that align with the round holes on the canopy (C) and loosen the
other two canopy screws making sure not to remove them. Raise canopy (C) over the hanging
bracket (A) aligning the screws that remained into the canopy (C). Twist canopy (C) clockwise to
secure. Reinstall the two screws that were previously removed into the holes on the canopy (C).
Tighten all screws.
11. Attach blade iron (D) to blade (K) with blade screws.
Do not tighten blade screws until each screw has
been started. Then, tighten each screw starting with
the center screw.
Repeat for remaining blades
12. Insert blade iron (D) into slot on the motor assembly
(F). Align the holes on the blade iron (D) with the
holes on the blade holder and secure with the 3
blade iron screws from the hardware bag.
Repeat for remaining blade assemblies
A A
11
12
11
A
A C
K
D
F
D