How To Disassemble And Clean - Kuvings M1 Manuel

HOW TO DISASSEMBLE AND CLEAN

1 1
Switch OFF and unplug the power cord
from the wall outlet.
Note |
• Extract all the remaining pulp in the
juicing bowl before stopping the juicer.
• For easier clean up, operate the juicer for
an additional 30 seconds after the juice is
extracted.
• When the drum lid is stuck, press the
REVERSE – OFF – FORWARD button in
this order, switching back and forth 2 to
3 times to dislodge. Then place hands
on top of the drum lid and firmly press
down simultaneously turning the drum
lid counter clockwise to open.
2 Turn the drum lid counter clockwise to
open.
When moving the appliance, do not lift by
Note |
grabbing the feeding tube. Always lift the
appliance by grabbing the base or handle.
3 Turn the top-set counter clockwise and lift
off the base.
16
4
Remove the juicing screw, strainer and
rotation wiper unit from the juicing bowl.
Clean with provided brush.
Note |
• Immediately clean the juicer after each
use. If remaining residue in the juicer dries
up, it can make disassembling and clean-
up diffi cult. The excess build up can cause
poor performance in future uses.
• For easier disassembly, place the top-
set in the sink and run the water through
from the top of the top-set.
• Thoroughly dry the bottom of the juicing
screw where it connects to the metal
cylinder shaft on the base.
Place the juicing bowl under running
5
water and unplug the compression
silicone to clean the pulp spout.
Tip | • Soak the juicing bowl in a solution of
warm water with baking soda or little bit
of bleach to clean the excess build up.
* The products illustrated/photographed in this booklet may vary slightly from the actual product.
6
Under running water, clean the outside
of the juicing screw with a dish scrub. Use
the tip of the cleaning brush to push out
any residue in the crevices on the bottom
of the juicing screw.
Tip | • Thoroughly clean the juicing screw
ensuring that the juicing screw is clean
without any residue.
• Completely dry before using.
Note |
• After juicing ingredients with seeds, make
sure to thoroughly clean the bottom
crevice of the juicing screw. If this area
isn't properly cleaned, it can aff ect the
balance between the juicing screw and
the strainer and damage the parts.
Clean the base with a soft damp towel
7
and dry.
Note |
• If the towel is dripping wet, make sure
to squeeze out the excess liquid before
using it on the juicer.
Quick Rinsing
1 With the smart cap closed, fi ll the
juicing bowl with water and turn on
the juicer.
2 Let it run for a moment. Open the
smart cap and let the water run out
of the juicing bowl.
Tip |
• It is not necessary to completely
clean the juicer in between making
multiple juices during a single juicing
session.
• When fi nished with juicing, always
disassemble and clean thoroughly
between juicing sessions to prevent
residue buildup.
17