Winix L500 HLUU750-JWE Manuel D'utilisation page 5

05. Programmable Humidistat
• The default humidistat setting is CO. (continuous) The
programmable humidistat can be set in 5% increments,
from 40% to 60% humidity.
• Manual humidity is set in 40% > 45% > 50% > 55% > 60%
> CO order.
NOTE: When the set humidity level is reached, the
humidifier will cycle off until the humidity in the room
drops 5% below the set humidity level, then will cycle on
until the set humidity level is reached again.
06. Adjustable Mist Level
• Mist adjusts from the lowest output to the highest
output.
• The corresponding mist level will be lit on the display.
Each press will increase by one.
• Once you reach level 5, it will repeat at level 1.
07. LightCel™ (UV+)
• Displays the operation status of the UV-C LED that
sterilizes the flow path of the reservoir.
• Power of the product is activated and turned off when
no water is detected.
NOTE: LightCel TM Technology Removes bacteria*
present in water, Ensuring a safe and sanitized mist for
you and your family.
(*Based on independent laboratory test conducted on
Escherichia coil, Staphylococcus aureus, Salmonella
typhimurium, Klebsiella pneumoniae)
English
08. Warm Light
• If you select warm humidification, it turns on.
09. Timer/Display Light
• When a time reservation is set, it turns on and displays
the time on the display.
10. Empty Tank Alarm
• If there is not enough water, the unit will stop and the
red LED indicator will continue to blink at the same
time.
11. Mist Level Indicator
• Displays the humidity level and goes up one step each
time the humidity level button is pressed.
|
L500 5