Honeywell Home Q3200U Notice D'installation

Q3200U/Q3205U Universal Hot
Surface Igniter Kit
1-23/64
(35)
1-25/32
(45)
2-13/16
(72)
15-45/64
(399)
GLOWFLY
Fig. 1.
APPLICATION
The Q3200U and Q3205U Universal Hot Surface igniter
Kit is designed to provide a robust field service
replacement igniter in gas fired appliances with Norton /
St Gobain 12Vac Silicon Carbide Hot Surface Igniters.
They use a 120 Volt Silicon Nitride igniter designed with
long life and high resistance to damage or burn out in the
appliance. The kit includes the specially designed silicon
nitride igniter and six different bracket configurations to
adapt the igniter to the specific appliance application
along with accessory parts to allow mounting and wiring
of the igniter. Clear instructions and application templates
are provided to simplify selection of the proper bracket
and ease installation of the replacement.
1-21/32
(42)
2-19/64
(58)
3-23/64
(85)
15-45/64
(399)
GLOWFLY PRO
M37744
INSTALLATION INSTRUCTIONS
BEFORE YOU START
1. Review this instruction sheet fully to ensure you are
familiar with the steps and information necessary to
complete the installation properly, including the
WARNING section on this page.
2. Confirm the existing hot surface igniter has failed:
a. Run an appliance cycle and observe the installed
igniter.
b. If the igniter glows, the problem is not the igniter.
c. If the igniter does not glow during an ignition
cycle:
(1) Unplug the igniter lead wires.
(2) Set a voltmeter's scale to 300 VAC and con-
nect the voltmeter to the igniter harness.
(3) Run another cycle and confirm 120 VAC
power at the harness during the igniter warm
up time.
3. Check the appliance construction and wiring dia-
gram (typically located on an appliance panel) and
confirm that the appliance does not use the hot sur-
face igniter as the flame sensor. Do not use the
Q3200 or Q3205 kit if the existing igniter is also the
flame sensor. Use an original equipment part. The
Q3200/Q3205 is not designed to be used as a flame
sensor.
4. If the appliance is a sealed combustion model,
determine if the existing hot surface igniter ceramic
is part of the sealing of the burner box. If it is, check
carefully to determine if this kit will allow the proper
appliance function.
5. Confirm the kit components:
a. six brackets stamped A, B, C, D, E, and F
b. one hot surface igniter with wiring leads
c. two wire nuts and a thread forming screw
6. The Q3200/Q3205 should not be handled by the
black silicon nitride igniter. Use care to handle the
Q3200/Q3205 by the ceramic casing or the bracket.
INSTALLATION
When Installing This Product...
1. Read these instructions carefully. Failure to follow them
could damage the product or cause a hazardous condi-
tion.
2. Check the cross reference table on page 5 and the
templates (Fig. 2 on page 3 and Fig. 3 on page 4) to
make sure the proper igniter bracket is used for your
application.
69-2334EF-01