Accessories; Environmental Notice - Braun 7 Serie Mode D'emploi

Cleaning the housing
From time to time clean the housing of the
shaver and the Clean&Renew station with a
damp cloth, especially inside the cleaning
chamber where the shaver rests.
Replacing the cleaning cartridge
After having pressed the lift button
housing, wait for a few seconds before removing
the used cartridge to avoid any dripping.
Before discarding the used cartridge, make sure
to close the openings using the lid of the new
cartridge, since the used cartridge will contain
contaminated cleaning solution.
Keeping your shaver in top shape
Replacing the Foil & Cutter cassette / reset
To maintain 100% shaving performance, re-
place the Foil & Cutter cassette
replacement symbol lights up on the shaver
z
display (after about 18 months) or when
cassette is worn.
The replacement symbol will remind you during
the next 7 shaves to replace the Foil & Cutter
cassette. Then the shaver will automatically reset
the display.
After you have replaced the Foil & Cutter
cassette, use a ball-point pen to push the reset
t
button for at least 3 seconds to reset the
counter. While doing so, the replacement light
blinks and goes off when the reset is complete.
The manual reset can be done at any time.

Accessories

Available at your dealer or Braun Service
Centers:
• Foil & Cutter cassette 70S
• Cleaning cartridge Clean&Renew CCR

Environmental notice

This appliance contains rechargeable
batteries. To protect the environment,
do not dispose of the appliance in the
household waste at the end of its useful life.
Disposal can take place at a Braun Service
Center or appropriate collection sites.
2
to open the
8
, when the
old old
new new
Series 7 Series 7
70S 70S
r e l e as e r e l e as e
70S 70S
11