Mounting The Collecting Bin; Operation - Garden GROOM Midi Mode D'emploi

Mounting the collecting bin

1. Set the device down so that the blade is pointing up and hold it in place with one hand on the handle.
2. Fold the locking lever to the outside with your other hand.
3. Set the collecting bin on the device with the vents up and the wider, open side pointing towards the
cutting head.
4. Push the bin under the cutting head until it locks into place and then push it down from above. A pin is
located on the bottom of the bin. It must audibly lock into the device's locking mechanism.
5. Fold the lever back to its previous position and push it into the indentation on the adapter.
6. Make sure that the adapter is securely seated.

Operation

•
Keep all body parts away from the cutting blades. Do not attempt to remove cuttings or
take hold of the material being cut when the blades are rotating. Only remove cuttings that
have accumulated in the device after you have deactivated the device and disconnected
the plug from the socket. Wear work gloves when doing so!
•
Carry the hedge trimmer by the handle when the blades are not moving.
•
Attention! This device generates noise up to 98 dB (A). For this reason, you should wear
adequate ear protection!
•
For your safety wear a mask.
•
This device runs with an integrated (electrical) motor brake for your convenience and safety. It
ensures that the cutting unit immediately stops when the switches are released.
•
Always wear protective eyewear
1. Connect the power plug to an easily accessible socket using an extension cord. The socket must
correspond to the device's technical data. If the collection accessories have been connected properly, the
operating light will turn on.
2. In order to activate the device, push the safety lock forward (this will release the main switch 1) and depress
the switches 1 and 2. After you have pressed switch 1, you can release the safety lock.However, as soon as
you release one of the switches, the device will deactivate.
3. Move the device evenly over the hedge and back and forth along its sides until you have shaped the hedge
as desired.
4. From time to time, shake any waste located in the hose down into the collection bag. Only in this way is it
possible to work without the cuttings causing a blockage.
5. After use, remove the collecting bin and/or collection system and empty them. Remove any cuttings jammed
in the device.
6. Stow the device and accessories in a place, which is not accessible for children, which is kept locked, and
is dry.
All manuals and user guides at all-guides.com
.9.