AquaScape Pro Air 20 Mode D'emploi page 4

STEP 1
UNPACK KIT COMPONENTS
• Carefully unpack the kit components.
STEP 2
SET COMPRESSOR
• Set the compressor in the desired location. Select a
location near a ground fault circuit interrupter (GFCI) rated
receptacle.
Note: Do not submerge
the compressor in water.
We recommend placing
it in a location above
the pond's water level,
whenever possible,
to prevent water from
entering the compressor.
STEP 3
ATTACH TUBING
• Attach the braided tubing with the pre-installed check
valve to the barbed compressor outlet.
Note: The check valve is designed to prevent water
from siphoning back through the tubing and entering the
compressor. Failure to install the check valve may result in
the compressor being permanently damaged, voiding the
warranty. Confirm that the check valve is facing the correct
direction by verifying that air is able to flow freely through
the tubing toward the diffuser.
4
STEP 4
SECURE TUBING TO MANIFOLD
• Use a stainless steel hose clamp to secure the tubing to
the manifold outlets.
STEP 5
ATTACH DIFFUSER
• Attach the other end of the braided tubing to the diffuser.
STEP 6
SECURE TUBING TO DIFFUSER
• Use a stainless steel hose clamp to secure the tubing onto
the diffuser.
☎ ☎
US (866) 877-6637 | CAN (866) 766-3426 | aquascapeinc.com